Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Repair Across Boulder City
If your driveway gate has stopped opening, is dragging on the ground, or the operator quit mid-cycle, call us at (855) 928-1304. We repair electric and automatic gates across Boulder City, from the 1930s bungalows in the Historic District near Nevada Way and Arizona Street to newer infill homes off Buchanan Boulevard. A live person answers the phone any hour, and most gate repairs are finished in a single visit. Boulder City isn’t Las Vegas or Henderson, and we work the town as it actually is: narrow lots, vintage posts, alley access, and a lot of gates that were never properly set up for automation in the first place.
Why Ironworks Gate Co. Whitney Is Boulder City’s Preferred Gate Repair Company
Boulder City homeowners tend to keep their homes for decades, and they call back the people who did the work right. That suits us. Our technicians have up to 13 years of experience, we’re trained and equipped on nine gate-automation brands, and every job ends with the wording we take seriously: done right, and backed in writing.
Boulder City’s heat and sun do their damage quietly. West-facing gates take the worst of the afternoon UV, which bakes finishes, swells wood frames, and wears out hinges, operators, and seals long before the hardware’s rated life. We know where that shows up first, and we know how the desert clay beneath the historic core moves with the seasons. That’s why a “hinge problem” on a 1940s masonry post often turns out to be a footing problem, and why we check the post before we sell you a hinge.
We answer the phone 24 hours a day, 7 days a week. Not a voicemail tree. Not an answering service. A live person who can get a technician to your Boulder City driveway, usually the same day you call. Every completed job carries our written 90-Day Done Right Promise: if it isn’t right, we come back and make it right.
Key Takeaways
- Live phone support around the clock at (855) 928-1304, with most repairs done in one visit.
- Upfront pricing settled before a bolt is turned, backed by a written 90-Day Done Right Promise.
- Experienced on LiftMaster, FAAC, BFT, Linear, Viking, and four more brands.
- Standing offers: $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a 5% senior and veteran discount.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Gate Repair Services in Boulder City
We handle the whole scope of driveway and estate gate work in Boulder City: Gate Repair, motors and openers, access control, and parts and welding. These are the four calls we get most.
Electric Gate Repair in Boulder City
Electric gates that won’t open, won’t close, or open halfway and stall are usually an operator problem, a wiring problem, or both. In Boulder City we look hard at the hinge post first, because a sagging gate fights the motor every cycle and eventually wins. We test the operator, the power run, and the gate’s balance before we recommend anything.

Automatic Gate Repair in Boulder City
Most automatic gate failures in Boulder City’s newer neighborhoods trace back to builder-grade equipment and after-the-fact wiring. A unit that was sized for a lighter gate, run on an undersized circuit, and asked to fight an unbalanced swing will strip gears or burn out in a few years. We’re certified on LiftMaster, FAAC, BFT, and Linear, so we fix the unit you have on the first visit rather than guessing at it.

Hinge & Post Repair in Boulder City
On historic-district lots, the gate often hangs off a vintage masonry or stucco pillar poured decades ago, and the shrinking and expanding desert clay has cracked or settled it. Bolting a new hinge plate onto a failing post just postpones the problem. We repair and, where needed, rebuild the footing so the gate hangs true for the long haul.

Gate Realignment in Boulder City
A gate that drags, scrapes, or won’t latch is out of plumb, and tightening the hinges rarely fixes a post that has moved with the ground. We realign the gate to the post and correct the sag, then reset the operator’s travel limits so the repair stays put through monsoon season.
Trusted Brands We Service in Boulder City
We’re trained and equipped on nine major gate-automation brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That range matters in Boulder City, where one gate runs a builder-grade LiftMaster and the next property has a Viking or BFT from an earlier install. We don’t keep a parts warehouse, but we diagnose accurately, order what’s needed, and get you back to a working gate without repeat visits for a misdiagnosed motor.
See the difference
Before
After
Before
After
Before
AfterCommon Gate Repair Problems We See in Boulder City Homes
These are the failures that come up again and again on Boulder City properties, and most of them start before the gate ever fails.
- Builder-grade operators on manually hung gates. A swing gate that was installed by hand and never balanced or reinforced for automation makes the motor do all the work. The unit runs hot every cycle, and eventually it strips a gear or quits.
- Missing or undersized power and conduit runs. In the newer infill developments, automation was often wired in after the build with surface-run conduit. Colorado sun and 100°F-plus summers break that down, and the operator fails intermittently until the run backs up to code.
- Hinge posts cracking in desert clay. The expansive clay under Boulder City swells and shrinks all year. Old masonry and wood posts crack and settle, the gate sags, and it’s easy to blame the hinge or the motor when the footing is the real problem.
- Heat and UV wear on west-facing gates. Sun-baked finishes fail, wood frames warp, and hinges and seals wear out early. Gates in full afternoon sun at the edge of the historic core age faster than shaded ones a few blocks away.
Pricing for Gate Repair in Boulder City, NV
Gate repair in Boulder City generally runs $150 for a minor adjustment up to about $900 for operator replacement, and you’ll get a firm price before we start. A hinge and post repair on a vintage masonry pillar typically lands between $250 and $650, while gate realignment and sag correction runs about $150 to $400. Automatic gate repair, including operator diagnostics and a power or conduit fix, commonly comes in at $200 to $700 depending on the brand and whether wiring is involved. Every quote is settled upfront, so the bill matches the number you agreed to. Free estimates on any written quote, and $50 off any repair over $250.
We Also Serve Cities Near Boulder City
Boulder City homeowners and their neighbors across the Las Vegas Valley call us for the same work. We connect households with independent local professionals for Gate Repair in Boulder City and the surrounding communities, including Henderson, Whitney, Paradise, and Enterprise. If you’re on the road between there and the lake, we’ll get a technician your way.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Gate Repair in Boulder City
They fail because builder-grade operators are put on manual gates that were never balanced or reinforced for automation, and the power runs are often undersized. The motor ends up fighting a sagging gate on a strained circuit, which strips gears or burns out the unit within a few years. A proper repair checks the post and the wiring before the operator is replaced, and we do that on the first visit. Call (855) 928-1304 for a free estimate.
Yes, a manual gate can be automated, but only after the gate is balanced and the hinge post is checked for settling in the clay. Slapping an opener on a gate that binds or drags is how operators fail early. We measure the gate, check the post and footing, and recommend a unit rated for its weight and daily cycles, with a written price before any work begins. Call (855) 928-1304 to schedule a free measure.
Entrapment protection is the safety system that stops or reverses a gate when something is in its path, and Boulder City gates on automatic operators need it to meet code and protect anyone nearby. It usually means photo eyes, edge sensors, or both, wired to the operator. We test and repair those safety edges as part of automatic gate service. Call (855) 928-1304 for a free estimate.
A sagging gate that stays saggy means the hinge post has moved, not the hinge, and in Boulder City that’s often the desert clay settling or cracking a vintage masonry or wood pillar. Tightening the hinge won’t fix a post that has shifted. The fix is realigning the gate and repairing or reinforcing the footing. Call (855) 928-1304 and we’ll take a look.
If your operator stalls intermittently, trips repeatedly, or runs off exposed wiring that’s baked by the sun, it likely needs a dedicated power and conduit run rather than a patch. Undersized or surface-run wiring is common on Boulder City gates automated after the build. A technician can check the circuit and the run and tell you what’s actually required. Call (855) 928-1304 for a free estimate.
When your gate isn’t working, you want it fixed once, by someone who’ll stand behind it in writing. Call us at (855) 928-1304 for a free estimate anywhere in Boulder City. A live person answers every call, day or night, and your price is settled before a single bolt is turned.
Written by the team at Ironworks Gate Co. Whitney.